ndctl-enable−namespace(1)

NAME SYNOPSIS THEORY OF OPERATION OPTIONS COPYRIGHT SEE ALSO

NAME

ndctl−enable−namespace − enable the given namespace(s)

SYNOPSIS

ndctl enable−namespace <namespace> [<options>]

THEORY OF OPERATION

The capacity of an NVDIMM REGION (contiguous span of persistent memory) is accessed via one or more NAMESPACE devices. REGION is the Linux term for what ACPI and UEFI call a DIMM−interleave−set, or a system−physical−address−range that is striped (by the memory controller) across one or more memory modules.

The UEFI specification defines the NVDIMM Label Protocol as the combination of label area access methods and a data format for provisioning one or more NAMESPACE objects from a REGION. Note that label support is optional and if Linux does not detect the label capability it will automatically instantiate a "label−less" namespace per region. Examples of label−less namespaces are the ones created by the kernel’s memmap=ss!nn command line option (see the nvdimm wiki on kernel.org), or NVDIMMs without a valid namespace index in their label area.

A namespace can be provisioned to operate in one of 4 modes, fsdax, devdax, sector, and raw. Here are the expected usage models for these modes:

• fsdax: Filesystem−DAX mode is the default mode of a namespace when specifying ndctl create−namespace with no options. It creates a block device (/dev/pmemX[.Y]) that supports the DAX capabilities of Linux filesystems (xfs and ext4 to date). DAX removes the page cache from the I/O path and allows mmap(2) to establish direct mappings to persistent memory media. The DAX capability enables workloads / working−sets that would exceed the capacity of the page cache to scale up to the capacity of persistent memory. Workloads that fit in page cache or perform bulk data transfers may not see benefit from DAX. When in doubt, pick this mode.

• devdax: Device−DAX mode enables similar mmap(2) DAX mapping capabilities as Filesystem−DAX. However, instead of a block−device that can support a DAX−enabled filesystem, this mode emits a single character device file (/dev/daxX.Y). Use this mode to assign persistent memory to a virtual−machine, register persistent memory for RDMA, or when gigantic mappings are needed.

• sector: Use this mode to host legacy filesystems that do not checksum metadata or applications that are not prepared for torn sectors after a crash. Expected usage for this mode is for small boot volumes. This mode is compatible with other operating systems.

• raw: Raw mode is effectively just a memory disk that does not support DAX. Typically this indicates a namespace that was created by tooling or another operating system that did not know how to create a Linux fsdax or devdax mode namespace. This mode is compatible with other operating systems, but again, does not support DAX operation.

OPTIONS

A namespaceX.Y device name. The keyword all can be specified to carry out the operation on every namespace in the system, optionally filtered by region (see −−region=option)

−r, −−region=

A regionX device name, or a region id number. The keyword all can be specified to carry out the operation on every region in the system, optionally filtered by bus id (see −−bus= option).

−b, −−bus=

Enforce that the operation only be carried on devices that are attached to the given bus. Where bus can be a provider name or a bus id number.

−v, −−verbose

Emit debug messages for the namespace operation

COPYRIGHT

Copyright (c) 2016 − 2019, Intel Corporation. License GPLv2: GNU GPL version 2 http://gnu.org/licenses/gpl.html. This is free software: you are free to change and redistribute it. There is NO WARRANTY, to the extent permitted by law.

SEE ALSO

ndctl−disable−namespace(1)